Cisco TelePresence System Codec C-Series Administrator's Guide

D14636.13 Profile C60-C40 and Codec C60-C40 Administrator Guide TC7.0, DECEMBER 2013. www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
87
Cisco TelePresence System Codec C40/C60 and Profiles using C40/60 Administrator Guide
NetworkPort settings
NetworkPort [2] Mode
Define if the network port 2 shall be enabled for direct pairing with a Cisco TelePresence Touch
screen control panel.
NOTE: Restart the system for any change to this setting to take effect.
Requires user role: ADMIN
Value space: <Inactive/DirectPairing>
Inactive: Set the NetworkPort 2 to Inactive when no device is connected.
DirectPairing: Set the NetworkPort 2 to DirectPairing when you have a Cisco TelePresence
Touch screen control panel connected to the port. This will enable for direct pairing between
the Touch screen control panel and the codec.
Example:
NetworkPort 2 Mode: Inactive
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
System settings

Cisco TelePresence System Codec C-Series Specifications

General

Brand	Cisco
Model	TelePresence System Codec C-Series
Category	Conference System
Language	English