Cisco TelePresence System Codec C-Series Reference Guide

D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 93
Cisco TelePresence System Codec C40/C60 API Reference Guide
xCommand Audio LocalOutput ConnectInput
Connect a local or remote input to a local output by giving their IDs as parameters.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio LocalOutput ConnectInput OutputId:6 InputId:3
OK
*r AudioOutputGroupConnectInputResult (status=OK):
** end
xCommand Audio LocalOutput UpdateInputGain
Update the gain of a local or remote input connected to a local output. The gain on the input signal
is in the range from -54dB to 15dB. The value -54dB equals Off.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio LocalOutput UpdateInputGain OutputId:6 InputId:3
OK
*r AudioOutputGroupUpdateInputGainResult (status=OK):
** end
xCommand Audio LocalOutput DisconnectInput
Disconnect a local or remote input from a local output.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
Example:
xCommand Audio LocalOutput DisconnectInput OutputId:6 InputId:3
OK
*r AudioOutputGroupDisconnectInputResult (status=OK):
** end
xCommand Audio RemoteOutput ConnectInput
Connect a local or remote input to a remote output with their IDs as parameters. When a call is
made a remote input and remote output pair is created.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio RemoteOutput ConnectInput OutputId:10 InputId:8
OK
*r AudioRemoteOutputGroupConnectInputResult (status=OK):
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence System Codec C-Series Specifications

General

Brand	Cisco
Model	TelePresence System Codec C-Series
Category	Conference System
Language	English