EasyManuals Logo

Cisco TelePresence System Codec C60 Reference Guide

Cisco TelePresence System Codec C60
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 110
Cisco TelePresence System Codec C40/C60 API Reference Guide
FacilityService commands
xCommand FacilityService Dial
Dial out from the system to a facility service. A maximum of five facility services can be defined;
which one of these five to dial to is identified by the ServiceId (ref. xConfiguration Facility Service
[ServiceId] Type/Name/Number/CallType). The command returns information about the CallId and
ConferenceId.
ServiceId: The identifier of the facility service.
Requires user role: USER
Parameters:
ServiceId(r): <1..5>
Example:
xCommand FacilityService Dial ServiceId: 1
OK
*r FacilityServiceDialResult (status=OK):
CallId: 2
ConferenceId: 1
** end
FarEndControl commands
xCommand FarEndControl Camera Move
Move the far end camera (the remote camera). NOTE: The far end camera moves in the specified
direction until the stop command (ref: xCommand FarEndControl Camera Stop) is issued
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
Value: Select the action for how to move the camera.
Requires user role: USER
Parameters:
CallId: <0..65534>
Value(r): <Left/Right/Up/Down/ZoomIn/ZoomOut>
Example:
xCommand FarEndControl Camera Move CallId:3 Value:left
*r FECCMoveResult (status=OK):
** end
xCommand FarEndControl Camera Stop
Stop the far end camera after the xCommand FarEndControl Camera Move has been issued.
CallId: The CallID is returned when the xCommand Dial command is run. During the call you can run
the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId: <0..65534>
Example:
xCommand FarEndControl Camera Stop CallId:3
*r FECCMoveResult (status=OK):
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Other manuals for Cisco TelePresence System Codec C60

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco TelePresence System Codec C60 and is the answer not in the manual?

Cisco TelePresence System Codec C60 Specifications

General IconGeneral
BrandCisco
ModelTelePresence System Codec C60
CategoryConference System
LanguageEnglish

Related product manuals