Cisco TelePresence System Codec C60 Reference Guide

D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 114
Cisco TelePresence System Codec C40/C60 API Reference Guide
Message commands
xCommand Message Alert Display
Display a message on screen, for a specified duration of time (in seconds). NOTE: If Duration is not
set, the command must be followed by xCommand Message Alert Clear.
Use the xFeedback commands to monitor the feedback from the user. Read more about the
xFeedback commands in the API introduction section in this guide.
Title: Enter a message title.
Text: Enter the message to be displayed. The <p> and <br> HTML tags will result in line breaks as
normal; any other tags will appear as plain text.
Duration: Set how long (in seconds) the message is to be displayed on the screen. If set to 0 (zero)
the message does not disappear until a xCommand Message Alert Clear message has been sent.
Requires user role: ADMIN
Parameters:
Title: <S: 0, 255>
Text(r): <S: 0, 255>
Duration: <0..3600>
Example:
xCommand Message Alert Display Title: "Message" Text: "The meeting will
end in 5 minutes." Duration: 20
OK
*r MessageAlertDisplayResult (status=OK):
** end
xCommand Message Alert Clear
Remove the message which was displayed using the xCommand Message Alert Display command.
This is required when the Duration parameter is not set.
Requires user role: ADMIN
Example:
xCommand Message Alert Clear
OK
*r MessageAlertClearResult (status=OK):
** end
xCommand Message TextLine Display
Display a text line on screen. Optionally you can place the text line at a specified location and for a
specified duration of time (in seconds). NOTE: If Duration is not set, the command must be followed
by xCommand Message TextLine Clear.
Text: Enter the text line to be displayed. The <p> and <br> HTML tags will result in line breaks as
normal; any other tags will appear as plain text.
X: Enter the X-coordinate (horizontal) on screen. X=0 is in the upper left corner.
Y: Enter the Y-coordinate (vertical) on screen. Y=0 is in the upper left corner.
Duration: Set how long (in seconds) the text line is to be displayed on the screen. If set to 0 (zero)
the text line is displayed until a xCommand Message TextLine Clear command has been sent.
Requires user role: ADMIN
Parameters:
Text(r): <S: 0, 140>
X: <1..10000>
Y: <1..10000>
Duration: <0..3600>
Example:
xCommand Message TextLine Display Text: "The message to be displayed."
X:500 Y:2000 Duration: 20
OK
*r MessageTextLineDisplayResult (status=OK):
** end
xCommand Message TextLine Clear
Clears the text line which was defined by the xCommand Message TextLine Display command.
Requires user role: ADMIN
Example:
xCommand Message TextLine Clear
OK
*r MessageTextLineClearResult (status=OK):
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence System Codec C60 Specifications

General

Brand	Cisco
Model	TelePresence System Codec C60
Category	Conference System
Language	English