Cisco TelePresence System Codec C60 Reference Guide

D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 149
Cisco TelePresence System Codec C40/C60 API Reference Guide
xStatus Audio Input LocalInput [n] AGC
Shows the AGC (Automatic Gain Control) mode on the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [n] of the input.
Value space of the result returned:
<"O n"/"Of f ">
Example:
xStatus Audio Input LocalInput 1 AGC
*s Audio Input LocalInput 1 AGC: "On"
** end
xStatus Audio Input LocalInput [n] Connector
Lists the connectors that are attached to the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [n] of the input.
Value space of the result returned:
<"Microphone.1"/../"Microphone.4"/"Line.1"/"Line.2"/"HDMI.2">
Example:
xStatus Audio Input LocalInput 1 Connector
*s Audio Input LocalInput 1 Connector: "Microphone.1"
** end
xStatus Audio Input RemoteInput [n] CallId
Shows the CallId for the remote audio input.
You can run the command xStatus Audio Input RemoteInput to find the identity [n] of the input.
Value space of the result returned:
<0..65534>
Example:
xStatus Audio Input RemoteInput 8 CallId
*s Audio Input RemoteInput 8 CallId: 28
** end
xStatus Audio Input Connectors Microphone [n] EcReferenceDelay
Returns the detected latency for each loudspeaker to microphone path. The result is in milliseconds.
Value space of the result returned:
<Integer>
Example:
xStatus Audio Input Connectors Microphone 1 EcReferenceDelay
*s Audio Connectors Microphone 1 EcReferenceDelay: 120
** end
xStatus Audio Output LocalOutput [n] Name
Shows the name of the local output.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the output.
Value space of the result returned:
<String>
Example:
xStatus Audio Output LocalOutput 4 Name
*s Audio Output LocalOutput 4 Name: "MyLocalOutput1"
** end
xStatus Audio Output LocalOutput [n] Loudspeaker
Shows the Loudspeaker mode on the local output. If one or more of the output connectors that are
attached to the local output are connected to a loudspeaker, then this signal should be a reference
signal to the echo canceler and Loudspeaker should be set to On.
You can run the command xStatus Audio Output LocalOutput to find the identity [n] of the output.
Value space of the result returned:
<"O n"/"Of f ">
Example:
xStatus Audio Output LocalOutput 4 Loudspeaker
*s Audio Output LocalOutput 4 Loudspeaker: "Off"
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatusxStatus

Cisco TelePresence System Codec C60 Specifications

General

Brand	Cisco
Model	TelePresence System Codec C60
Category	Conference System
Language	English