EasyManua.ls Logo

Cisco TelePresence System Codec C60

Cisco TelePresence System Codec C60
224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 94
Cisco TelePresence System Codec C40/C60 API Reference Guide
xCommand Audio RemoteOutput UpdateInputGain
Update the gain of a local or remote input connected to a remote output.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
InputGain: Set a gain on the input signal in the range from -54dB to 15dB. The value -54dB equals
Off.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
InputGain: <-54..15>
Example:
xCommand Audio RemoteOutput UpdateInputGain OutputId:6 InputId:3
OK
*r AudioRemoteOutputGroupUpdateInputGainResult (status=OK):
** end
xCommand Audio RemoteOutput DisconnectInput
Disconnect a local or remote input from a remote output with their IDs as parameters.
OutputId: A unique identifier for the local output.
InputId: A unique identifier for the local or remote input.
Requires user role: ADMIN
Parameters:
OutputId(r): <0..65534>
InputId(r): <0..65534>
Example:
xCommand Audio RemoteOutput DisconnectInput OutputId:10 InputId:8
OK
*r AudioRemoteOutputGroupDisconnectInputResult (status=OK):
** end
xCommand Audio Setup Clear
Remove all local inputs and local outputs.
Requires user role: ADMIN
Example:
xCommand Audio Setup Clear
*r AudioSetupClearResult (status=OK):
** end
xCommand Audio Sound Play
Play a specified audio sound.
Requires user role: USER
Parameters:
Sound(r): <Bump/Busy/CallDisconnect/CallInitiate/CallWaiting/Dial/KeyInput/KeyTone/Nav/
NavBack/Notification/OK/PresentationConnect/Ringing/SpecialInfo/TelephoneCall/VideoCall/
Volume>
Loop: <On/Off>
Example:
xCommand Audio Sound Play Sound: Ringing
*r AudioSoundPlayResult (status=OK):
** end
xCommand Audio Sound Stop
Stop playing audio sound.
Requires user role: USER
Example:
xCommand Audio Sound Stop
*r AudioSoundStopResult (status=OK):
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Other manuals for Cisco TelePresence System Codec C60

Related product manuals