or WAP571E Wireless Access Point.
Connect the WAP571E to the Network via PoE
Prepare the Cabling
Step 1. Disassemble the weather-proof connector to expose the red rubber gasket. After
disassembling, you should have the following:
1 Thick rubber gasket1.
Part B of the weather-proof connector2.
Thin rubber gasket3.
Part A of the weather-proof connector4.
Step 2. Slide the Ethernet cable through Part B of the weather-proof connector.
Step 3. Pinch the thick rubber gasket to reveal the cut and then slide the Ethernet cable through
the cut.
To Next Page
Loading...
