To Next PageTo Next Page
Need help?Do you have a question about the Cisco WAP150 and is the answer not in the manual?
General| VLAN support | Yes |
|---|---|
| Number of users | 64 user(s) |
| Networking standards | IEEE 802.11ac, IEEE 802.11b, IEEE 802.11e, IEEE 802.11g, IEEE 802.11i, IEEE 802.11n, IEEE 802.1Q, IEEE 802.1x, IEEE 802.3af, IEEE 802.3u |
| Ethernet LAN data rates | 10, 100, 1000 Mbit/s |
| Maximum data transfer rate | 1200 Mbit/s |
| Antenna type | Internal |
| Placement | Table, Wall |
| Cable lock slot type | Kensington |
| Security algorithms | HTTPS, SSID, WPA, WPA2 |
| Service Set Identifier (SSID) features | SSID broadcast on/off |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 0 - 40 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
| USB 2.0 ports quantity | 0 |
Weight and Dimensions| Depth | 38 mm |
|---|---|
| Width | 135 mm |
| Weight | 350 g |
Manages device firmware, including upgrading and swapping active/inactive images.
Configures network interface settings including IP, VLANs, STP, and discovery protocols.
Manages users, system identification, security settings like SNMP, 802.1X, and password complexity.
Configures wireless radio parameters like mode, channel, band, and advanced features.
Configures Access Control Lists (ACLs) to permit or deny network traffic based on defined rules.
Manages Quality of Service (QoS) for wireless clients, classifying and prioritizing traffic.
