Cisco WAP150 - Guest Group Table

Address-2Address-1Regions
35.246.18.8235.230.139.41EUROPE
35.244.98.24735.244.93.31ASIA-PACIFIC
The value for Key-1 and Key-2 is 6n8!5ETGb^nd
• RADIUS Accounting — Check Enable to track and measure the resources that a particular user has
consumed, such as the system time and the amount of data transmitted and received.
If you enable RADIUS accounting, it is enabled for the primary RADIUS server and the backup server.
• Guest Group — If the Authentication Method is set to Local Database or Radius Authenticated, select a Guest
Group that was created previously . All users who belong to the group are permitted to access the network through
this portal.
• Redirect URL — To enable the URL Redirect, enter the URL (including http://). The range is from 0 to 256
characters.
• Session Timeout (min.) — Enter the time remaining, in minutes, for the CP session to be valid. After the time
reaches zero, the client is de-authenticated. The range is from 0 to 1440 minutes. The default value is 0. The session
timeout got from the Radius Server will over ride the user configured timeout in the event of a session timeout.
• Web Portal Locale — Select a web portal locale that was created previously from the drop-down list.
Step 4 Click Apply . Your changes are saved to the Startup Configuration.
Redirect URL and Web Portal Locale are not of use in EXCAP mode.
Please refer to Hardware manual in Purple Wi-Fi for more detailed settings of EXCAP
Note
Guest Group Table
On the device, each local user is assigned to a user group and the group is assigned to a CP instance. The
group facilitates managing the assignment of users to CP instances.
The user group named Default is built-in and cannot be deleted.
To configure a local user:
Step 1 Select Guest Access > Guest Group Table.
Step 2 In the Guest Groups Settings area, configure the following parameters:
• Guest Group Name — Specify the name for the new guest group. The default Guest Group Name is Default
Step 3 Configure these parameters:
• Idle Timeout — Enter the period of time that a user remains in the CP authenticated client list after the client
disassociates from the WAP device. If the time specified in this field expires before the client attempts to
re-authenticate, the client entry is removed from the authenticated client list. The range is from 0 to 1440 minutes.
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
100
Access Control
Guest Group Table