• Splash Page URL — Enter the URL (including https://) for the portal page which is obtained after
successful registration into the Purple WiFi. The range is 0 to 256 characters. The EXCAP hosts the initial
login page called the splash page on the cloud or on an external web server which may be outside the AP
network. For example: https://region3.purpleportal.net/access/ if your region is ASIA-PACIFIC in Purple
Wi-Fi.
• Walled Garden — Specify a list of domains that users can access before passing through the Web portal
page. Items in the list should be separated by a comma, and domains can include wildcards in the form of
an asterisk (*). The length of each domain cannot be greater than 100. Ensure that the total length of the
Walled Garden must be less than 4096. The following options should be set if you want to use them on
Purple Wi-Fi’s EXCAP solution:
purpleportal.net, cloudfront.net, venuewifi.com, openweathermap.org, stripe.comPurple WiFi
(MUST)
facebook.com, fbcdn.net, akamaihd.net, facebook.netFacebook
(Optional)
twitter.com, twimg.comTwitter (Optional)
linkedin.com, licdn.net, licdn.comLinkedIn
(Optional)
instagram.comInstagram
(Optional)
vk.com, vk.meVkontakte
(Optional)
• RADIUS Server IP Address-1 — Enter the IPv4 address for the primary RADIUS server for this VAP.
The IPv4 address should be in a form similar to xxx.xxx.xxx.xxx.
When the first wireless client tries to authenticate with a VAP, the WAP device sends an authentication
request to the primary server. If the primary server responds to the authentication request, the WAP device
continues to use this RADIUS server as the primary server, and the authentication requests are sent to the
specified address.
• RADIUS Server IP Address-2 — Enter the IPv4 backup RADIUS server addresses. If the authentication
fails with the primary server, the configured backup server is tried.
• Key-1 — Enter the shared secret key that the WAP device uses to authenticate to the primary RADIUS
server. You can use up to 63 standard alphanumeric and special characters. The key is case sensitive and
must match the key configured on the RADIUS server. For example, the secret can be 6n8!5ETGb^nd if
you use Purple Wi-Fi. The text that you enter is shown as asterisks.
• Key-2 — Enter the RADIUS key associated with the configured backup RADIUS servers. The server at
Server IP Address-1 uses Key-1, Server IP Address-2 uses Key-2.
For the Purple WiFi, the Server IP Address-1 and Address-2 varies for different regions. The table below
specifies the same:
Address-2Address-1Regions
34.94.183.20134.94.146.135AMERICAS
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
99
Access Control
Guest Access Instance Table
To Next Page
Loading...
