Cisco WAP150 - Qos Policy

If Protocol is All Traffic, Source Address and Destination Address are not optional.
Note
• Class Of Service — Specifies the class of service 802.1p user priority value.
• Any — Allows for any class of service.
• User Defined — Enter an 802.1p user priority to compare against an Ethernet frame. The valid range is from
0 to 7.
• VLAN ID — The VLAN ID to compare against an Ethernet frame.
• Any — Allows for any VLAN ID.
• User Defined — Enter the specific VLAN ID to compare against an Ethernet frame. This field is located in
the first/only 802.1Q VLAN tag. The port range is 1 to 4094.
Step 8 Click OK. The changes are saved to the Startup Configuration.
To delete or modify a class map, choose the class map from the list and click Delete or Edit. The class map
cannot be deleted if it is already attached to a policy.
Note
Step 9 Click Apply.
QoS Policy
Packets are classified and processed based on the defined criteria. The classification criteria is defined by a
class on the Traffic Classes page. The processing is defined by a policy attributes on the QoS Policy page.
Policy attributes may be defined on a per-class instance basis and determine how traffic that matches the class
criteria is handled.
The WAP device can hold up to 50 policies and up to 10 classes in each policy.
To add and configure a policy map:
Step 1 Select Client QoS > QoS Policy.
Step 2 Click ✚ to add a QoS Policy. In the QoS Policy Name field, enter the name for the QoS policy. The name can contain
from 1 to 31 alphanumeric and special characters. Spaces are not allowed.
Step 3 You can select an associated traffic class that was created previously.
Step 4 Configure these parameters for the policy map:
• Committed Rate (Kbps) — The committed rate, in Kbps, to which traffic must conform. The range is from 1 to
1000000 Kbps.
• Committed Burst (Bytes) — The committed burst size, in bytes, to which traffic must conform. The range is from
1 to 204800000 bytes.
• Action — Select from one of the following options:
• Send — Specifies that all packets for the associated traffic stream are to be forwarded if the traffic class criteria
is met.
Cisco WAP150 Wireless-AC/N Dual Radio Access Point with PoE / Cisco WAP361 Wireless-AC/N Dual Radio Wall Plate Access Point with PoE
94
Access Control
QoS Policy