Cisco Wireless 9176I Series - Page 4

Preinstallation Checks and Installation Guidelines 14
Mounting the Access Point 16
Powering the Access Point 17
Configuring and Deploying the Access Point 19
CHAPTER 4
The Controller Discovery Process 19
Deploying the Access Point on a Wireless Network 20
Checking the Access Point LEDs 20
Troubleshooting 23
CHAPTER 5
Using the Reset Button 23
Troubleshooting the Access Point to Cisco Controller Join Process 24
Important Information for Controller-Based Deployments 25
Configuring DHCP Option 43 25
Safety Guidelines and Warnings 27
CHAPTER 6
Safety Instructions 27
Declarations of Conformity and Regulatory Information 29
CHAPTER 7
Manufacturers Federal Communication Commission Declaration of Conformity Statement 29
VCCI Statement for Japan 30
Guidelines for Operating Cisco Catalyst Access Points in Japan 31
Canadian Compliance Statement 32
European Community, Switzerland, Norway, Iceland, and Liechtenstein Compliance 33
United Kingdom Compliance 33
Administrative Rules for Cisco Catalyst Access Points in Taiwan 34
Operation of Cisco Catalyst Access Points in Brazil 34
Declaration of Conformity for RF Exposure 35
Generic Discussion on RF Exposure 35
This Device Meets International Guidelines for Exposure to Radio Waves 35
This Device Meets FCC Guidelines for Exposure to Radio Waves 36
This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves 36
Additional Information on RF Exposure 37
Declaration of Conformity Statements 38
Cisco Wireless 9176I Series Wi-Fi 7 Access Point Hardware Installation Guide
iv
Contents