Cisco WRP400 - Page 29

29
Regulatory Compliance and Safety Information for the Cisco WRP400 Wireless-G Broadband Router with 2 Phone Ports
78-20472-01
Authorized External Antennas and Corresponding Power Levels
Guidelines for Operating Cisco WRP400 Wireless-G Broadband Router in
Japan
This section provides guidelines for avoiding interference when operating a Cisco WRP400 Wireless-G
Broadband Router in Japan. These guidelines are provided in both English and Japanese.
Statement 391—Warning for Low-Power Radio Data Communications
Systems (-STD)
Warning This equipment shares a frequency band with a wide range of equipment: e.g. industrial,
scientific, and medical equipment such as microwave ovens, premises radio stations (radio
stations requiring licenses), and specified low-power radio stations (radio stations not requiring
licenses) for RFID used for factory production lines as well as amateur radio stations (radio
stations requiring licenses).


1. Before use, confirm that no premises radio stations and specified low-power radio stations
for RFID or amateur radio stations operate in your vicinity.


2. In the event that this equipment causes harmful interference to any premises radio station
for RFID, immediately change frequencies or halt radio wave emission and contact us at the
information indicated below for consultation on interference avoidance measures (e.g.,
partition installation).


3. Contact us at the information indicated below if this equipment causes harmful interference
to any specified low-power radio stations for RFID or amateur radio stations or if other
problems arise.
Statement 391 

Contact us at : http://www.cisco.com/jp/