32
Regulatory Compliance and Safety Information for the Cisco WRP400 Wireless-G Broadband Router with 2 Phone Ports
78-20472-01
Brazil
Brazil
The WRP400 has been approved for use in Brazil.
Compliance Mark
Below is the Anatel Approval mark which can be found on the underside of the product.
The Anatel approval number is 0281-11-1086
Radio Warning
The WRP400 radio operates on 2.4GHz unlicensed frequencies and as required by Anatel Resolution
No. 365 – Article 6, the following interference warning statement must be provided, see below:
EU
This system has been evaluated for RF exposure for Humans in reference to the ICNIRP (International
Commission on Non-Ionizing Radiation Protection) limits. The evaluation was based on the EN 50385
Product Standard to Demonstrate Compliance of Radio Base stations and Fixed Terminals for Wireless
Telecommunications Systems with basic restrictions or reference levels related to Human Exposure to
Radio Frequency Electromagnetic Fields from 300 MHz to 40 GHz. The minimum separation distance
from the antenna to general bystander is 20cm (7.9 inches).
Australia
This system has been evaluated for RF exposure for Humans as referenced in the Australian Radiation
Protection standard and has been evaluated to the ICNIRP (International Commission on Non-Ionizing
Radiation Protection)limits. The minimum separation distance from the antenna to general bystander
is 20cm (7.9 inches).
Generic Statements - for other countries
ANSI C 95.1 (99)
This system has been evaluated for RF exposure for Humans in reference to the ANSI (American
National Standards Institute)limits as referenced in C 95.1 (99). The minimum separation distance
from the antenna to the user is 7.9 inches (20cm).
ICNIRP Limits
This system has been evaluated for RF exposure for Humans in reference to the ICNIRP (International
Commission on Non-Ionizing Radiation Protection) limits. The minimum separation distance from the
antenna to the user is 20cm (7.9 inches).
To Next Page
Loading...
