Citadel XR1 - User Manual

Intruder alarm system
Operating
Instructions
Key
These operating
instructions cover the
following intruder
system:
ÿ
8EP 394 XR1G3
panel with built in
keypad
For Clarity, the
information given on
setting the system,
assume that all Programs
use a timed or final door
setting routine.
Unset system indications
An unset system will have both Day and Power
indicators lit. This is a normal
indication when the system is
disarmed.
Note: If the Power indicator goes off at
any time then there is a mains supply
failure at the security panel, consult your
servicing organisation.
Set System indication
An active ‘Set’ system will have only the Power
indicator lit. This is an armed
system indication.
4188 693 issue 1 8/01 1
Unset system indications
Power
0123
5678
Chime Omit
Reset
4
9
Set
Prog
PA
Attack
Tamper
Day
1 2 3 4 5 6 7 8
8EP 394 XR1 G3 panel
with built-in keypad
Power
/!
mini
0123
5678
h m mi
R s t
4
9
S t
P o
A
A tack
Tamper
Day
1 2 3 4 5 6 7 8
LED steady On indication
LED Off
Strobe
Bell
NOTE: In general a flat beep is
an indication of an incorrect key press.
Sound description
Internal sound
External devices
LED flashing indication
Day
Powe
r
Powe
r
XR1
www.ukpanels.com
All manuals and user guides at all-guides.com
all-guides.com

Summary

CITADEL XRI Intruder System Operation

Unset System Indications

Displays indicators for an unset system, including Day and Power status.

Set System Indication

Shows the Power indicator lit for an armed system.

Access Codes

Explains the use of 4-digit user codes for system operation.

System Setting Procedures

Covers setting the system via code, push-to-set, or keyswitch.

Quick Set and Zone Omission

Details quick setting and omitting zones during system arming.

Chime Zone Configuration

Configures zones to chime on activation while the system is unset.

Operator Programming and System Management

Operators Program Mode Overview

Overview of programmable options and how to change them.

Event Log Viewing

Accessing and scrolling through up to 8 previous system events.

User Code Management

Creating, omitting, or changing user codes for system access.

Alarm and Walk Test Procedures

Procedures for testing alarm functions and detector operation.

Servicing Organisation Details

Fields for recording maintenance and support contact information.

Quick Reference and System Status

Quick Reference - Setting and Unsetting

Summarized steps for setting, unsetting, and resetting the system.

System Status Indications

Explains normal unset indications and specific alarm indicators.

Citadel XR1 Specifications