Why is the battery voltage low on my citEcar Bubble Buddy Golf Cars?
Low battery voltage in your citEcar Golf Car can occur if the battery voltage is below the cutback threshold. To resolve this, charge or replace the battery. Additionally, check for corroded battery terminals and clean them if necessary. Also, ensure that the battery or controller terminals are not loose and tighten them.
Why did the aux relay not close in my citEcar Bubble Buddy?
If the aux relay did not close in your citEcar Golf Cars, it might be due to the aux relay missing or the wire to the coil being open. Inspect and repair the aux relay.
What to do if the main contactor is open in my citEcar Bubble Buddy?
If the main contactor is open in your citEcar Golf Cars, it is likely defective and needs to be replaced.
What causes a field winding fault in citEcar Bubble Buddy?
A field winding fault in your citEcar Golf Cars can be caused by loose motor field wiring. Check and tighten the motor field wiring. Alternatively, the motor field wiring might be open, requiring repair or replacement.
How to fix SRO fault in citEcar Bubble Buddy?
If the key switch is not off during power-up or is shorted in your citEcar Golf Cars, it can cause a SRO fault. Ensure the key switch is off during power-up. If the issue persists, replace the key switch.
Why is the main contactor coil held low in my citEcar Bubble Buddy?
If the main contactor coil is held low in your citEcar Golf Cars, it could be due to the main contactor missing or the wire to the coil being open. Check for the main contactor and repair the wiring. Alternatively, the controller might be defective, requiring replacement.
What causes thermal cutback in citEcar Golf Cars?
Thermal cutback in citEcar Golf Cars can occur if the temperature is greater than 85°C or less than -25°C. Ensure the vehicle operates within specified temperature limits. It may also happen if there is excessive load on the vehicle, so reduce the load. Improper mounting of the controller can also cause this, so mount the controller properly. Finally, operating in extreme environments can lead to thermal cutback, so avoid extreme operating conditions.
Why am I getting an overvoltage error on my citEcar Bubble Buddy Golf Cars?
Overvoltage in your citEcar Golf Cars can happen if the battery voltage is under voltage cutback threshold. Make sure to check the battery voltage. It could also be because the vehicle is being operated with the charger still attached, so remove the charger. Another reason might be that the battery was disconnected during regenerative braking; in this case, reconnect the battery properly.
What to do if my citEcar Golf Cars motor stalls?
If your citEcar Golf Cars motor stalls, it could be due to several reasons. The slope might be too steep for the vehicle's weight, so check and reduce the slope if needed. The motor could be mechanically locked, requiring inspection and freeing. A failure in the EM brake wiring could also be the cause, so check the EM brake wiring. Lastly, a defective speed sensor can cause this issue, so consider replacing the speed sensor.
Details operation of the ignition key and forward/reverse selector switch.
Crucial safety guidelines before and during vehicle operation.
Step-by-step guide for starting and stopping the vehicle safely.
Procedures for cleaning, checking, and recharging the vehicle's battery.
Overview of diagnostic features and troubleshooting guides for system issues.
General| Seating Capacity | 2 |
|---|---|
| Voltage | 48V |
| Battery Capacity | 100 Ah |
| Max Speed | 25 mph |
| Range per Charge | 50 miles |
| Dimensions (L x W x H) | 96" x 48" x 72" |
| Tire Size | 18x8.5-8 |
| Motor | Electric |
To Next Page