CITIZEN QUARTZ
ANA-DIGI
Model No. 30-7XXX, JMOXXX
Cal. No. C20❈, C480, T011
• INSTRUCTION MANUAL
CTZ-6751
1. SELECTING BASIC FUNCTIONS
Press
M
button to select functions.
• Alarm, Stopwatch and calendar modes are
indicated by each flashing mode mark.
• Crown – Analog display set,
M – Mode change, Instant manual return
S – Selection, Reset, Split
R – Adjustment, Start, Stop, Alarm Set,
Illumination
★ The Cal. C20❈ doesn’t have any STOPWATCH
or CALENDAR mode mark.
2. ADJUSTING THE ANALOG DISPLAY
Pull out the crown one step and
turn clockwise or
counterclockwise direction to
adjust the analog time display.
The seconds hand will start
timekeeping synchronising with
the digital time display when the
crown is returned to the original
position.
3. ADJUSTING THE DIGITAL TIME DISPLAY
1. Press
M
button to set to
the normal TIME display
2. Press
S button until
SECONDS start flashing.
3. Press
R to set seconds to
“00”.
4. Press
S for MINUTES
adjustment. MINUTES
start flashing.
5. Press
R and adjust the
minutes.
6. Press
S
for Hours
adjustment. HOURS start
flashing.
7. Press
R
and adjust the
hours.
8. Press
S for 12/24 HOURS
selection. 12/24 HOURS
starts flashing.
9. Press
R and select 12 or
24-HOUR display.
10. Press
S
or
M
to finalise
adjustment. The watch
returns to the normal
TIME display.
• If the watch is left in the adjustment mode for
about one minute without operating any buttons,
AUTO RETURN will activate to return to the
normal TIME display.
• If seconds adjustment is made when the SECOND
display is showing 30-59 seconds, the MINUTE
display will automatically advance to the next
minute.
• INSTANT MANUAL RETURN to the normal time
display can be made at any stage of adjustment by
pressing
M button.
• A and P marks display only under the 12-hour time
system.
TIME ALARM STOPWATCH CALENDAR
TIME
TIME
SECONDS
MINUTES
HOURS
12/24 HOURS
To Next Page
Need help?
General