Citizen B740 - 13. ALL RESET;ADJUSTING HAND POSITION; Full reset and hand adjustment

5150
13. ALL RESET/ADJUSTING HAND POSITION
(1) Unscrew the crown and pull it out to
the second click stop position.
(2) Press buttons A and B
simultaneously. If the function hand
moves slightly, the watch is reset in
whole.
(3) Press button A or B to set the
function hand and mode hand to their
respective “0” positions.
Button A: For adjustment counter-
clockwise.
Button B: For adjustment clockwise.
* The function hand and the mode
hand move interlocking with each
other.
(4) Correct the time indication by turning
the crown. (Refer to “8. ADJUSTING
TIME AND DATE (Time mode)”.)
0
m
3
0
4
0
2
0
3
6
9
1
2
1
5
5
0
L
V
.
2
L
V
.
1
N
G
50
10
30
20
40
D
V
50
10
D
V
Mode hand
Function
hand
Adjusting position
B
A
(5) Press the crown in to the normal position and screw it down tightly against
the case.
As the crown is pressed into the normal position, the watch returns to the
Time mode and starts running.
* After the watch is reset, the function hand points at “NG” position
regardless of remaining battery power. Approximately 1 hour after resetting,
the function hand will indicate the charge level. (While the function hand is
indicating “NG”, the watch cannot be switched to the Diving mode.)
* If the ALL RESET/ADJUSTING HAND POSITION fails in clearing away the
trouble, consult with the store where you purchased the watch or the
nearest Citizen Service Center about the trouble.
Note that the maximum depth memorized during the last dive is
cleared simultaneously during ALL RESET.