- Eng 8 -
3.3 Pressurize the cuff
Pressurize the cuff by pumping bulb until you have a reading of
approximately 30 to 40 mmHg higher than your regular systolic
blood pressure.
Note: At pressure of 140,170, 200, 240 mmHg, the buzzer beeps
two times.
When pressurization is completed, the automatic the automatic
air release system will gradually reduce cuff pressure, and Mea-
suring Mark “Q” will appear on the display indication that mea-
surement is in progress.
When a pulse is detected, the pressure value moves to the right
side of the display. At this time Measuring Mark “Q” flashes with
a short beep at the same time as pulse rate.
When the diastolic pressure valve is detected, the measurement is
completed and buzzer beep.
Systolic pressure is displayed on the left and diastolic pressure on
the right side of the display.
After completion of measurement, the mark “▼” appears.
Approximately 2 seconds later, blood pressure values and pulse
appear alternatively on the display.
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE / min
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE / min
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE / min
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE / min
SYSTOLIC mmHg DIASTOLIC mmHg
PULSE / min
To Next Page
Loading...
