Citizen CHU305 - Starting and Completing Measurement

- Eng 14 -
English
Español
4 Press the “ START/STOP” switch.
* If the previous user had a high pressuer setting, that high pressure will
automatically be used for the current measurement.
* If the pressurization value exceeds 260 mmHg, if pressurization feels
abnormal, or if you want to stop the measurement process, press the
“
START/STOP” switch again. The cuff deflates, and the power turns off.
• A beep is heard and all digits displayed is an initial display, indicating that the
monitor is functioning normal.
• The cuff is pressurized automatically.
*
If the unit judges that pressurization is insufficient, it automatically repressurizes.
* The un it automatically sets the pressure based on the previous measurement.
* is displayed when a pulse is detected.
* When you want to stop measurement, press the “ START/STOP” switch.
The cuff is deflated and measurement stops.
5 The measurement results are displayed.
• Once measurement is complete,
the cuff deflates and the
measurement results (systolic/
diastolic blood pressure values,
pulse) are displayed.
* Systolic/diastolic blood
pressure values and pulse are
displayed alternately.
* Provided there is no error in
the measurement results, they
are stored automatically.
6 Finishing measurement.
START/STOP
Switch
Hypertension Classification lndicator
(
See page 15)
• Press the “ START/STOP”
switch to turn the monitor off.
00CHU305USA.indbEng-1400CHU305USA.indbEng-14 2015/01/1319:53:202015/01/1319:53:20