Citizen CHUD514 User Manual (English)

Questions and Answers:

A
Andrea MullenAug 3, 2025
Why does my Citizen Blood Pressure Monitor give abnormal results?
- M
  Maria CarrAug 3, 2025
  If you get an abnormal result with your Citizen Blood Pressure Monitor, several factors could be the cause. First, ensure the cuff is correctly positioned and properly tightened. Incorrect body posture during measurement can also lead to abnormal results, so review the posture guidelines and try again. Movement, speaking, or being in an emotional state (angry, excited, or nervous) during the measurement can also interfere; try again when calm and still. Finally, an irregular heartbeat can cause this issue, in which case you should consult your physician.
R
Rebecca NormanAug 9, 2025
What to do if my Citizen CHUD514 does not respond?
- A
  andrew63Aug 9, 2025
  If your Citizen Blood Pressure Monitor doesn't respond when you press a button or load the battery, it might be due to a few reasons. It could be caused by incorrect operation or strong electromagnetic interference. To solve this, take out the batteries for five minutes, and then re-insert them. Alternatively, the batteries may be low, so try changing them.
K
kelly47Aug 16, 2025
What to do if my Citizen CHUD514 shows “Er 5”?
- R
  richardcortezAug 16, 2025
  If your Citizen Blood Pressure Monitor displays “Er 5”, it indicates that the cuff pressure has exceeded 300 mmHg. Wait five minutes and measure again. If the LCD still shows the same error, contact your local distributor.
M
matamargaretAug 21, 2025
What does “Er 3” mean on my Citizen CHUD514 Blood Pressure Monitor?
- J
  Jonathan DominguezAug 21, 2025
  If your Citizen Blood Pressure Monitor displays “Er 3”, it means the pneumatic system is blocked or the cuff is too tight during inflation. To fix this, ensure you attach the cuff correctly and then try again.
A
abigailgreenAug 28, 2025
What does “Er 0” mean on my Citizen CHUD514 Blood Pressure Monitor?
- L
  Lawrence ChambersAug 28, 2025
  If your Citizen Blood Pressure Monitor shows “Er 0”, it indicates that the pressure system is unstable before measurement. To resolve this, remain still and try taking the measurement again.