Citizen E660 - Checking the reference position; Correcting the reference position; Resetting the watch - All Reset; All Reset procedure and settings

Resetting the watch — All Reset
1.
Pull the crown out to position
1
.
2.
Rotate the crown to move the mode hand to point [CHR].
3.
Pull the crown out to position
2
.
The hands and indication move to the current reference positions stored in
memory.
• Proceed to the next step when the hands and indication stop.
4.
Press and release both the lower right button
A
and upper
right button
B
at the same time.
As you release the buttons, the alarm sounds and all reset is executed.
The setting values after All Reset
Time/calendar January 1, Sunday of leap year
World time LON
Summer time SMT OFF at all time zones
Alarm setting ALM OFF
Alarm time 0:00 AM
Reception result
indication
NO
After All Reset
After All Reset, adjust the reference position, set the time and calendar and
execute alarm setting.
60
SMT
ON OFF
S
S
F
M
T
T
W
24
ALM
ON
OFF
TME
TME
CHR
CHR
SET
SET
ALM
ALM
RX
NO
OK
LON
AKL
MDY
HNL
ANC
LAX
DEN
NOU
SYD
TYO
BJS
BKK
PAR
ATH
RUH
DXB
KHI
DAC
PDL
FEN
RIO
MAO
NYC
CHI
KM.
STAT.
NAUT.
70
80
90
10
55
50
45
40
35
30
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
1
31
1
31
Checking the reference position
1.
Pull the crown out to position
1
.
2.
Rotate the crown to move the mode hand to point [CHR].
3.
Pull the crown out to position
2
.
The hands and indication move to the current reference positions stored in
memory and stop.
4.
Check the reference position.
Correct reference positions:
•
Hour, minute and second hands: 0 hour
00 minute 0 second
• 24-hour hand: “24”
• Date indication: midway between “31”
and “1”
• Function indication “30” (straight
below)
When the current reference position is
different from the correct one, proceed to step 3 of “Correcting the reference
position”.
5.
Push the crown in to position
0
.
6.
Change the mode to [TME] to finish the procedure.
Correcting the reference position
1.
Pull the crown out to position
1
.
2.
Rotate the crown to move the mode hand to point [CHR].
3.
Pull the crown out to position
2
.
4.
Press and release the lower right button
A
.
The function hands move slightly.
5.
Press and release the lower right button
A
repeatedly to
change the hand/indication to be corrected.
• Each time you press the button, the target changes as follows:
Function hand/date indication → Hour/minute/24-hour hands → Second
hand
→ (back to the top)
• The hands slightly move when selected to show they become adjustable.
• The function hand points “60” (straight above) when the hour, minute,
second and 24-hour hands are the targets of adjustment.
6.
Rotate the crown to adjust the hand/indication.
• The hour, minute and 24-hour hands move synchronously.
• Date indication changes to the next as the function hand rotates 5 times.
• When you rotate the crown quickly a few times, the hand/indication will
move continuously. To stop the rapid movement, rotate the crown in either
direction.
7.
Repeat steps 5 and 6.
8.
Push the crown in to position
0
.
9.
Change the mode to [TME] to finish the procedure.
E660 Abbreviated instruction