63
Checking and correcting the reference position
1
Pull the crown out to position .
2
Press and hold the lower right button for
4 seconds.
The hands and date start to move to the current
reference positions stored in memory.
• Release the button as the hands start to move.
• Some hands shows special movement to adjust their
position.
3
Check the current reference position.
Refer to the figure on the previous page.
Correct
Push the crown in to position and press and
release the lower right button
to finish the
procedure.
Wrong
Proceed to step 4 in the next page and correct
the reference position.
To Next Page
Loading...
