E - 2
1 General Guide
1 - 1 Power supply
Turning on or off
To turn the calculator on, press [ ON ] ; To turn the calculator off, press
[ 2nd ] [ OFF ].
Battery replacement
SRP-280 is powered by two alkaline batteries (GP76A). SRP-285 is dual
power system which is powered by one alkaline battery (GP76A) and a solar
cell. If the display becomes dim and difficult to read (especially when lighting
is dim for SRP-285), the batteries should be replaced as soon as possible.
To replace batteries :
1) Remove the screws and the back cover.
2) Replace the old batteries and install new ones with polarity in
correct directions, then secure the screws in place and press
[ ON ] to turn the power on.
Auto power-off function
This calculator automatically turns it off when not operated for approximately
9~15 minutes. It can be reactivated by pressing [ ON ] key and the display,
memory, settings are retained.
Reset operation
If the calculator is on but you get unexpected results, press [ 2nd ]
[ RESET ] in sequence. A message appears on the display to confirm whether
you want to reset the calculator and clear memory contents.
RESET : N Y
Move the cursor to “ Y ” by [], then press [
ENTER
] to clear all variables,
programs, pending operations, statistical data, answers, all previous entries,
and memory; To abort the reset operation without clearing the calculator,
please choose “ N ” .
If the calculator is lock and further key operations becomes impossible, please
press [ 0 ] [ DMS ] at the same time to release the condition. It will return all
settings to default settings.
1 - 2 Contrast adjustment
Pressing the [
] or [] following [ MODE ] key can make the contrast of
the screen lighter or darker. Holding either key down will make the display
become respectively lighter or darker.
To Next Page
Loading...
Need help?
General
