4 Status menu
During normal operation of the controller, the display is in
the status level. This one indicates the measurement values
shown in the table.
In addition to the adjustment values, possible error messages
are indicated in the status menu (see chap. 64).
Display Description
BLPR1 Blocking protection R1
BLPR2 Blocking protection R2
BLPR3 Blocking protection R3
TCOL Temperature collector
TCOL1 Temperature collector 1
TCOL2 Temperature collector 2
TSTB Temperature store base
TST1B Temperature store 1 base
TSTT Temperature store top
TST2B Temperature store 2 base
TSFL Temperature solar flow
TSRE Temperature solar return
TSFB Temperature solid fuel boiler
TSTR Temperature store return preahting
TRET Temperature - return
S3 Temperature sensor 3
S4 Temperature sensor 4
S5 Temperature sensor 5
n1 Speed relay 1
n2 Speed relay 2
n3 Speed relay 3
n4 Status relay 4
Display Description
h R1 Operating hours relay 1
h R2 Operating hours relay 2
h R3 Operating hours relay 3
h R4 Operating hours relay 4
L/h Flow rate Grundfos sensor
BAR System pressure
TSFL Temperature solar flow VFS
TSRE Temperature solar return RPS
TFHQM Temperature flow heat quantity measure-
ment
TRHQM Temperature return heat quantity mea-
surement
L/h Flow rate V40 or flow gauge
kWh Heat quantity in kWh
MWh Heat quantity in MWh
TIME Time
DATE Date
*
R4 is a standard relay not suitable for speed control. Therefore,
its status is indicated with 0 % or 100% respectively.