Citrix SDX 11500 - Power Cycling the Appliance; To Power Cycle the Appliance; System Specifications

4. In the Password box, type nsroot.
5. In the Configuration tab, click Network and type values for the following
parameters:
• IP Address—IP address of the LOM port.
• Subnet Mask—Subnet mask used to define the subnet of the LOM port.
• Default Gateway—IP address of the router that connects the LOM port to the
network.
6. Click Save.
Power Cycling the Appliance
You can remotely turn off the appliance and turn it back on. The result is similar to
pressing the power button on the back panel of the appliance for less than four
seconds.
Note: Power cycling the appliance by using the LOM port is not supported in the
current release.
To power cycle the appliance
1. In a web browser, type the IP address of the LOM port.
2. In the User Name and Password boxes, type the administrator credentials.
3. In the Menu bar, click Remote Control.
4. Under Options, click Power Control, and then click Power Cycle System.
5. Click Perform Action.
System Specifications
The following table summarizes the specifications of the NetScaler SDX
11500/13500/14500/16500/18500/20500 appliances.
Specifications SDX
11500/13500/14500/16500/18500/205
00
Processor 2 six-core
Memory 48 GB
Quick Installation and Configuration
12