CITROEN C-CROSSER - Parking the vehicle

IX
PRA
C
TI
C
AL INF
O
RMATI
O
N
1
33
Fixing the "space-saver" spare
wheel
If your vehicle is fi tted with alloy
wheels, it is normal to notice that the
washers do not come into contact
with the "space-saver" spare wheel
when tightening the bolts on fi tting.
The wheel is retained by the conical
contact of each bolt.
Access to the s
p
are wheel in
the 7 seat confi
g
uration
The "space-saver" spare wheel is in-
stalled on the outside, under the boot,
supported by a metal carrier.
To gain access to the tools, refer to the
"Access to the tools" paragraph.
Putting the wheel back in place
) Put the wheel back in place in its
carrier.
) Lift the carrier C and reposition the
hook D .
) Open the lower tailgate (refer to the
"Access" section).
) Remove the plastic cover A using
the handle 3 .
) Unscrew the spare wheel carrier re-
taining bolt B using the wheelbrace 1 .
) Close the lower tailgate (refer to the
"Access" section).
) Lift the carrier C to detach the
hook D then allow it to lower.
) Tighten the spare wheel carrier re-
taining bolt B fully using the wheel-
brace 1 .
) Refi t the plastic cover A , close the
lower tailgate and store the tools.
Removing the wheel
) Open the tailgate and the lower tail-
gate (refer to the "Access" section).
) Take out the handle 3 (refer to the
"Access to the tools" paragraph).
https://www.automotive-manuals.net/