EasyManua.ls Logo

CITROEN C-Elysee - Lighting and visibility; Exterior lighting control stalk; Wiper control stalk

CITROEN C-Elysee
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
Lighting and visibility
4
Exterior lighting control
stalk
Main lighting
Lamps o󰀨 (ignition o󰀨)/
Daytime running lamps (engine running)
Sidelamps only
Dipped or main beam headlamps
Headlamp dipping
Pull the lighting control stalk to switch
between dipped and main beam headlamps.
In lamps o󰀨 and sidelamps modes, pull the
lighting control stalk to switch the main beam
headlamps on directly ("headlamp ash").
Display
Illumination of the corresponding indicator
lamp on the instrument panel conrms that the
selected lighting is on.
A fault with a lamp is signalled by the
permanent illumination of this warning
lamp, accompanied by the display of a message
and an audible signal.
Rear foglamp
They only work if the dipped or main
beam headlamps are on.
Rotate the ring forwards/backwards to turn
it on/o󰀨.
Front foglamps/Rear
foglamp
They operate with the dipped or main
beam headlamps on.
Rotate the ring forwards:
once to switch on the front foglamps,
a second time to switch on the rear foglamp.
Turn in the opposite direction to switch o󰀨.
Rotate the ring backwards to switch the
foglamps o󰀨; the sidelamps will then switch o󰀨.
Switching on the foglamps is prohibited
in clear weather or in rain, both day and
night. In these situations, the power of their
beams may dazzle other drivers. They must
only be used in fog or falling snow (rules may
vary depending on country).
Do not forget to switch o󰀨 the foglamps when
they are no longer necessary.
Switching o󰀨 of the lighting when the
ignition is switched o󰀨
When the ignition is switched o󰀨, all of the
lamps turn o󰀨 immediately, except for the
dipped beam headlamps if automatic guide-
me-home lighting is activated.
Switching on the lamps after
switching o󰀨 the ignition
To reactivate the lighting control, rotate the
ring to the "0" position - lamps o󰀨, then to the
desired position.

Related product manuals