CITROEN C-Elysee - Page 74

72
Practical information
Precautions for use
AdBlue
®
is a urea-based solution. This uid is
non-ammable, colourless and odourless (when
kept in a cool place).
In the event of contact with the skin, wash the
a󰀨ected area with soap and running water. In the
event of contact with the eyes, immediately rinse
the eyes with large amounts of water or with an
eye wash solution for at least 15 minutes. Seek
medical attention if you feel a persistent burning
sensation or irritation.
If swallowed, immediately wash out the mouth
with clean water and then drink plenty of water.
In certain conditions (high temperature, for
example), the risk of release of ammonia cannot
be excluded: do not inhale the uid. Ammonia
vapours have an irritant e󰀨ect on mucous
membranes (eyes, nose and throat).
Store AdBlue
®
out of the reach of
children, in its original container.
Procedure
Before starting the top-up procedure, ensure that
the vehicle is parked on a at and level surface.
In wintry conditions, ensure that the temperature
of the vehicle is above -11°C. Otherwise the
AdBlue
®
may be frozen and so cannot be poured
into the tank. Park the vehicle in a warmer area
for a few hours to allow the top-up to be carried
out.
Never pour the AdBlue
®
into the Diesel
fuel tank.
For specic information about how to
access the AdBlue tank, refer to the
detailed descriptions below.
If any AdBlue
®
is splashed, or if there are
any spillages on the bodywork, rinse
immediately with cold water or wipe with a
damp cloth.
If the uid has crystallised, clean it o󰀨 using a
sponge and hot water.
Important: in the event of a top-up after
an AdBlue breakdown, you must wait
about 5 minutes before switching on the
ignition, without opening the driver's door,
unlocking the vehicle or bringing the
electronic key into the passenger
compartment.
Switch on the ignition, then wait for 10
seconds before starting the engine.
►
Switch o󰀨 the ignition and remove the key
from the switch to switch o󰀨 the engine.
► Turn the blue cap of the AdBlue
®
tank anti-
clockwise and remove it.
Filling up
► With a bottle or container of AdBlue
®
: after
checking the expiry date, read the instructions
on the label carefully before pouring the contents
into the vehicle's AdBlue
®
tank.
►
With an AdBlue
®
pump: insert the nozzle and
ll the tank until the nozzle automatically cuts
out.
In order not to overll the AdBlue
®
tank:
–
Add between 10 and 13 litres using
AdBlue
®
containers.
–
Stop after the nozzle’s rst automatic cut-
out, if you are relling at a service station.
The system only registers AdBlue
®
intermediate top-ups of 5
litres or more.
If the AdBlue
®
tank is completely empty
– which is conrmed by the message