EasyManua.ls Logo

CITROEN C-Elysee - In the event of a breakdown; Warning triangle; Running out of fuel (Diesel)

CITROEN C-Elysee
180 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
83
In the event of a breakdown
8
Warning triangle
This reective and dismantable device is to be
installed on the side of the road when a vehicle
is broken down or damaged.
Before getting out of the vehicle
Turn on the hazard warning lamps, then
put on the safety vest to assemble and install
the triangle.
Assembling and placing the
triangle
For versions supplied with a triangle as original
equipment, refer to the illustration above.
For other versions, refer to the assembly
instructions provided with the triangle.
Put the triangle in place behind the vehicle,
as required by local legislation.
Running out of fuel
(Diesel)
With Diesel engines, the fuel system must be
primed if you run out of fuel.
Before starting to prime the system, it is
essential to put at least 5 litres of Diesel into the
fuel tank.
For more information on Refuelling and
on Misfuel prevention (Diesel), refer to
the corresponding section.
For non-BlueHDi versions, the fuel system
components are located in the engine
compartment; this may be under a removable
cover.
For more information on the Engine
compartment, in particular the location
of these components under the bonnet, refer
to the corresponding section.
1.6 HDi engines
Open the bonnet and then, if necessary,
unclip the cover to access the priming pump.
Operate the priming pump repeatedly
until resistance is felt (resistance may be
felt at the rst press).
Operate the starter motor to start the engine
(if the engine does not start at the rst attempt,
wait around 15 seconds before trying again).
If the engine does not start after a few
attempts, operate the priming pump again, then
the starter motor.
Put the cover back in place and clip it in, then
close the bonnet.
1.5 BlueHDi engines
Switch on the ignition (without starting the
engine).
Wait around 1 minute and switch o󰀨 the
ignition.
Operate the starter motor to start the engine.
If the engine does not start at the rst attempt,
do not keep trying, but restart the procedure.
Tool kit
Set of tools supplied with the vehicle.
Access to the tools
The tool kit is stored in the boot, under the oor.

Related product manuals