First make sure all the doors are closed.
The alarm is armed by pressing button
With the alarm armed, the protections are active after 5
seconds (perimeter) and 45 seconds (volumetric).
When the alarm is armed (on standby), any intrusion
will trigger the siren for 30 seconds, accompanied by
the direction indicators lighting up.
The alarm then goes back on standby, but the trigger-
ing remains memorised and is signalled by the rapid
fl ashing of the warning lamp on control
deactivated the alarm with a press on the unlocking
. The fl ashing stops when you switch on the
The siren is also triggered if there is a cutting of the
electrical supply. To stop it, restore the electrical supply
then press on the unlocking button
If you want to lock your vehicle without arming the
alarm, just lock with the key only.
If you lock your vehicle and a door, or the boot, is still
open, the central locking does not operate but the
alarm will arm itself after approx. 45 seconds.
The siren is automatically deactivated (for exam-
ple for disconnecting the battery) as soon as the vehicle
is unlocked using the remote control.
Deactivating the volumetric detection
You can operate the alarm with perimeter protection
only, by deactivating the volumetric protection (if for
example you wish to leave an animal in the vehicle).
For this, switch off the ignition then immediately press
The warning lamp on button
nently on. It will start to fl ash when the alarm is armed.
Arm the alarm by locking your vehicle with the remote
Automatic activation (according to destina-
The alarm is armed automatically, 2 minutes after the
last door, or the boot, has been closed.
In order to prevent the alarm from triggering when you
open one of the doors or the boot, it is essential to press
again on the remote control.
A N T I - I N T R U S I O N A L A R M
To Next Page
Loading...
