CITROEN C2 - WINDOWS; Electric operation; Sequential control on drivers side; Anti-pinch on drivers window

II
53
Electric operation
The switches on the console allow
the vehicle’s electric windows to be
controlled from the driver’s posi-
tion.
Sequential control on driv-
er's side
An action on the control to the fi rst
notch causes a window movement
which stops as soon as the control
is released.
An action on the control to the
second notch causes the window
to close or open completely, a fur-
ther press on the control stops the
movement.
Note:
The window controls also
operate for a limited time after you
have switched off the ignition.
ALWAYS PAY ATTENTION TO WHERE CHILDREN ARE WHEN
OPENING OR CLOSING THE WINDOWS
Always remove the ignition key when leaving the vehicle, even if for a
short time.
If there is an obstruction when operating a window, you must immedi-
ately reverse the window movement. To do that, reverse the position of
the control concerned.
If the driver is operating the electric window controls for passengers, he
or she should ensure that no passenger is obstructing the window from
closing.
The driver must ensure that the electric windows are used properly by
passengers.
Anti-pinch on driver's window
An anti-pinch device stops the window from rising. If it meets an obstacle, it
goes back down.
After a battery disconnection or if there has been a malfunction
, you
have to
re-initialise
the anti-pinch function:
Use the control to fully open the window, then reclose. It will rise only a
few centimetres.
Press again on the control until the window closes fully.
During this operation, the anti-pinch protection does not work.
Manual operation
Turn the handle to raise or lower the window.
•
•
W I N D O W S