If after around 5 to 7 minutes
the pressure is not attained, this
indicates that the tyre is not re-
pairable; contact a CITROËN
dealer for assistance.
Switch on the compressor by mo-
ving the switch B to position "1" until
the tyre pressure reaches 2.5 bars.
Remove the kit, taking care to avoid
to avoid staining your vehicle with
traces of fl uid. Keep the kit to hand.
Drive immediately for approximate-
ly three miles (fi ve kilometres), at
reduced speed (between 15 and
35 mph [20 and 60 km/h]), to plug
the puncture.
Stop to check the repair and the tyre
pressure using the kit.
Turn the selector A to the AIR position.
Connect the black pipe D to the
valve of the wheel.
Checking/Adjusting tyre
pressures
You can also use this kit for the
routine check and adjustment of
the tyre pressures on your ve-
hicle. For this, carry out just the
following 6 points.
To Next Page
Loading...
