HYDRAULIC
SYSTEM
SPECIFICATION - IDENTIFICATION : SUSPENSION SPHERES
Special features
Identification.
- Fitting of new slimline spheres with multilayer membranes, stone grey in colour.
- It is forbidden to recharge or overhaul this type of sphere.
- The number marked on the suspension sphere is the reference no. of the component and not the Part No.
- The two-figure number marked on the suspension sphere indicates the initial inflation pressure value.
Example :
- The pressure value of this type of suspension sphere is given merely as a guide.
- When checking, the value read could be higher than the nominal value.
NOTE : Suspension cylinders on the same axle should be equipped with the same type of membranes.
Tightening torques for these spheres : 2,7 ± 0,5 m.daN.
238
Suspension
sphere marking
96 420 906 80 AG2 066 0 13h59 57
Batch of steel
Day
of manufacture
Year
of manufacture
Time
of manufacture
Pressure rating
(Bars)
To Next Page
Loading...
