CITROEN CX - Page 207

Supplement 818-1
CORR
b;.
l-.
.,.'
'.a
.-.
,=Y
i11
OPE RATION
N° MÅ. 344-0
:
/étjn. J arv
fr(
Op. MÅ.
344-0
1
ADJ1JSTING
THE GEAR
LEVER
With
gear Icier set in neutral
Position
a)
the
lever
should
be
inclined
approximately 3
towards the rear in relation to the vertical axis
XX
of the vehicie.
If not
-
remove
dust cover
(
-
remove three screws (2),
shift
covr
(
3
)
to obtoin correct position
of
gear
lever.
NOTE
Should it be irnpossible
to
effect adjust-
ment by means of cover (3), make
necessary
adjustment at
control
shaft
hall joint
(5).
-
Tighten
three screws (2).
- Refit
dust cover
(1).
b)
the
gear lever
should
be located in
the longitu-
dinul axis
YY
of
the veh!cle.
If
not
=
Adjust
selector shaft hall
joint (4) to
obtain
this position.
NOTE
When adjusting hall
oints (4) or
5)
it is
imperative
that
the flats
(
- )
on each
shaft
are properly aligned.
,%/tr
ad/stinin t. c/'c ck that gear lr,cr
nut sclect
and
till gears.
PDF compression, OCR, web-optimization with CVISION's PdfCompressor