Supplement No. to Manual 818-1
''G
.-.
'-'
G-'
q..
`(°
0.'
a..
Cl)
'-'
i-.
.t2
i..
,-R
.-C
.l]
OPERATION N° MA.
01 :
I'roi(iiOn
of
f/1(
(I(c/rica/
au/is.
Op.
MA.
01
PROTECTION
OF
THE ELECTRICAL UNITS
PRECAUTIONS WHEN
CARRYING
OUT WORK ON THE
CAR
It is
ahsoli,te/y ussun
tia! lo
ajoki Or tio)) ubiri'
mar
(/rs/roy
(ur/Oj)) of
ii'u
('luc/ricO! 1/1/iis or creaie 0 shor/-circiiil
ih
con s c qii
c'
ut
risk
0!
Jiru
).
1. Battery
:
a)
Disconnect
the negative
terminal
first, then the positive one.
b)
Ensure
the battery
is
properly conriected, with the negative
terminal
being
connected
to earth.
c)
Corefully
connect
both
leods
to the battery terminals,
the negotive lead
being
connected
last.
Before
connecting the negative leod
ensure
that
there is no
flow
of current. This
can
be
estoblished
by
briefly touching the
negative
terminal with the
lead end :
sparks
indicate o
short circuit which must
be
corrected
first.
c
0
0
0
0
0
0
z
c
E
(1
0.
0
d)
Before
using the starter ensure that the
two
léads are correctly
tightened on
their
respective
terminals.
2. Alternator-Regulator
:
a)
Do
not rotate
the alternotor
unless it is connected
to
the battery.
b)
Before
connecting the olternator
ensure
that the battery
is correctly connected
(negativa terminol
to eorth).
c)
Do not
check
the operation of the
alternator by
shortcircuiting
either the positive
or
the
«
EXC
»
terminals ond the earth
terminal.
d)
Take care not
to
reverse the leads connected to the regulator.
e) Do not attempt to re-energize
the alternator :
this is
never
necessary
and in ony
case
would damage both
the alternator
and
the regulator.
f)
Do not connect
a
suppressor
capacitor at the
«
EXC
»
terminal of
the alternator or
the
regulator.
g) Do not connect
o chorging unit to
the battery and never carry out
arc
welding
(or spot
welding) on
the car chassis
unless
both
the
positive
and the negativa leuds
are
disconnected
from
the battery.
3.
Ignition
coli :
a) Connect the supply
lead of the coil to the
externol ballast resistor terminal
and not to
the coil itseif.
b)
Connect the
suppressor with a jump
lead to the feed terminal
of the coil.
Only fit
the
suppressor recommended
by the
factory.
4. Q.I. Headlamps
a) Only replace
a Q.I. buib with
the headlamps
switched off.
After having
used
the
head-
lamps it
is wise
to lat them
cool down for
five minutes before
handling.
b)
Do
not touch
a Q.I.
buib with
bare fingers.
Any
fingerprints
on the
bulb must be cleaned
off with soapy
water and the
buib dried with
a lint-free cloth.
PDF compression, OCR, web-optimization with CVISION's PdfCompressor
To Next Page
Loading...
