2 seconds and over
Hold down the SET key for 2 seconds or longer with screen F2 (zero/span adjustment) screen F2 displayed.F2 setting mode is entered.
Hold down the SET key for 2 seconds or longer with screen F3 (automatic power off) screen F3 displayed. The F3 setting mode will be entered.
Hold down the SET key for 2 seconds or longer in with screen F4 (switch output function) screen F4 displayed.F4 setting mode is entered.
Input the set value.
key: Moves digit
key: Counts up value
Input the set value.
key: Moves digit
key: Counts up value
*This function cannot be used when preset or direct memory input is selected with F1 (input signal selection). Only full scale is used.
2 seconds and over 2 seconds and over
*If a key is pressed during automatic power off, the display will turn on.
*The automatic power off time is set to about 1 minute, and cannot be changed.
Exits automatic power OFF setting mode, and returns to screen F3.
2 seconds and over
After setting, exits setting mode and returns to screen F2.
To use with full scale * Default
2 seconds and over
After setting, exits setting mode and returns to screen F2.
To use with adjusted zero/span
2 seconds and over
Input the set value.
key: Moves digit
key: Counts up value
Input the set value.
key: Moves digit
key: Counts up value
2 seconds and over 2 seconds and over
After setting, exits setting mode and returns to screen F4.
To enable switch output mode 1
2 seconds and over
Input the set value.
key: Moves digit
key: Counts up value
Input the set value.
key: Moves digit
key: Counts up value
2 seconds and over 2 seconds and over
After setting, exits setting mode and returns to screen F4.
To enable switch output mode 2
2 seconds and over
Exits zero/span adjustment
setting mode, and returns
to screen F2.
Exits the switch output
setting mode, and
returns to screen F4.
2 seconds and over
After setting, exits setting mode and returns to screen F3.
To disable automatic power off * Default
2 seconds and over
After setting, exits setting mode and returns to screen F3.
To enable automatic power off
2 seconds and over
After setting, exits setting mode and returns to screen F4.
To disable switch output * Default
2 seconds and over
Setting mode Setting method Caution
Release the key lock before changing setting details.(Refer to page 17)
16
EVD Series
How to operate
To Next Page
Loading...
