CKD INDEXMAN PPLX Series - Page 12

[SMB-20E]
― 11
―
ADEQUATE
OPERATION
４
 WARNING:
！
Don'tsuddenlystoptheinputshaftrevolutionduringthe
outputsectionisworking.
①Asuddenstopoftheinputshaftbyclutchbrakeetc.will
applytheoverloadtotheunit.Thismaycauseanoverrun
ofthedialplateontheunit.
②Ifatorquesaverisprovided,asuddenstopwillrelease
thetorquesaver.Thismaycauseanoverrunofthedial
plateontheunit.
③Iftheemergencystopisnecessary,installthesafety
measuretopreventasuddenstop,andselectthelarger
torquesaverenduringtheoverload.
(4) After emergency stop, manually rotate the shaft to the dwell section and start
again.
A handle should be provided with the driving system to permit the manual
rotation of the input shaft in such a case.
(5) Check for unusual sound.
If any unusual sound is heard during use, immediately stop the operation. The cam
follower or an internal part may have been failed. Contact the nearest sales agency or
factory.
(6) Prevention of water intrusion and corrosion
The Pick and Place unit input and output axis and mounting surfaces are not
protected from corrosion. They may be corroded depending on the storing
conditions or the operating atmosphere.
Always apply a coat of rust-preventive oil, grease, or rust proof paint over the
machined surfaces
.
 CAUTION:
！
Don'tusetheproductwherewetoroilyenvironment. 
Theproductisnotwater-proofordrip-proof.
Wheretheproductissubjecttosplashesofwateroroil,itmustbe
protectedwithacoverorsuch.
Input shaft pulley
Handle
Output shaft
Reduction gear
 WARNING:
！
Donotusetheproductinanexplosiveorignitableatmosphere
.