What to do if CKD Industrial Equipment Pick and Place unit body does not rotate?
If the CKD Industrial Equipment Pick and Place unit body does not rotate, the issue might be due to a faulty motor, in which case you should replace it. Alternatively, the brake may have been applied, requiring repair or replacement. Finally, check if the grease has run out, and if so, add grease.
Why is the stop position incorrect on my CKD INDEXMAN PPLX?
If the stop position of your CKD Industrial Equipment is incorrect, it might be due to an overload on the geared motor. To resolve this, reduce the carrying mass, or consider using a worm reduction gear.
How to fix a shock applied to the output arm or output table on CKD INDEXMAN PPLX Industrial Equipment?
If a shock is applied to the output arm or output table of your CKD Industrial Equipment, it could be because the timing belt is significantly slack when it is running. Tighten it using the tension adjuster.
What to do if CKD Industrial Equipment P & P unit is overloaded?
If the P & P unit of your CKD Industrial Equipment is used under a load exceeding the permissible carrying mass, recalculate the carrying mass, and consult us about measures.
What to do if the tightening torque is insufficient on CKD INDEXMAN PPLX Industrial Equipment?
If the tightening torque of your CKD Industrial Equipment is insufficient, or the bolt is loose, check and tighten it.
Why is there no shock when reducing input shaft speed on CKD INDEXMAN PPLX Industrial Equipment?
If no shock is produced by reducing the speed of the input shaft in your CKD Industrial Equipment, it might be because the carrying mass is excessive. Reconsider using another P & P model. If the problem persists, and there is something wrong with the driving system or another, please contact us.
How to stop key chatter when driven by gear in CKD INDEXMAN PPLX Industrial Equipment?
If the key chatters when driven by gear in your CKD Industrial Equipment, replace the key to reduce chatter.
What to do if internal damage is suspected in CKD INDEXMAN PPLX Industrial Equipment?
If you suspect internal damage to your CKD Industrial Equipment, contact us for replacement of Pick and Place unit.
How to fix backlash at worm reduction gear in CKD INDEXMAN PPLX Industrial Equipment?
If your CKD Industrial Equipment has backlash at the worm reduction gear, overhaul the worm reduction gear.
How to fix poor repeatability due to overload protector in CKD Industrial Equipment?
If you have poor repeatability due to the overload protector in your CKD Industrial Equipment, replace it.
General| Series | PPLX |
|---|---|
| Port Size | M5, Rc1/8, Rc1/4 (depending on model) |
| Material | Aluminum alloy, stainless steel |
| Mounting Type | Foot, Flange, Trunnion |
| Operating Pressure | 0.1 to 0.7 (MPa) |
To Next Page
