Claas QUADRANT 2200 User Manual

1 GENERAL NOTES
INTRODUCTION .........................
INTRODUCTION TO THE
CLAAS REPAIR HANDBOOK ..............
EXPLANION OF GRAPHIC SYMBOLS ...
GENERAL NOTES ON REIR ............
TORQUE SPECIFICIONS
Tightening torque (in Nm) for
hexagonal bolts, cylinder head bolts
1.1 / 1
1.1 / 1
1.2 / 1
1.3 /
1
and hexagonal nuts . . . . . . . . . . . . . . . . . . . . . . . 1 .4 / 1
rque specifications for
hydraulic connections with O-ring seals
complying with ISO 6149 . . . . . . . . . . . . . . . . . . 1.4 / 2
SPECIFICIONS
Oil quantities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5 / 1
BASIC SETTINGS FOR THE DRIVES
Adjusting the drives to the markings ........ 1.6 / 1
BASIC SETTINGS FOR THE
TWINE WRAP DEVICE ......................... .
Setting up the knotter shaft and needles . . . . . 1 . 7 / 1
Checking the setting of the needles
to the piston . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 7 / 4
Opportunities for control checks
in the bale chamber ....................... 1.7 / 5
Needle yoke brake . . . . . . . . . . . . . . . . . . . . . . . 1. 7 / 6
Kn otter shaft brake . . . . . . . . . . . . . . . . . . . . . . . 1 . 7 / 6
Adjusting the springs for
the clamping plates . . . . . . . . . . . . . . . . . . . . . . . 1 . 7 / 7
Adjusting the springs for
the kn otter hooks . . . . . . . . . . . . . . . . . . . . . . . . . 1 . 7 / 7
Setting up the play on
the knotter pinion . . . . . . . . . . . . . . . . . . . . . . . . . 1. 7 / 7
Twine finger ............................. 1.7 / 8
Ram stop ............................... 1.7 / 9
Find manuals at http://best-manuals.com/search?&s=CLA-2981710

Claas QUADRANT 2200 Specifications

General

Type	Square baler
Pick-up Width	2200 mm
Required Tractor Power	70-100 hp
Working Width	2200 mm
Pickup Width	2200 mm
Power Requirement	70-100 hp