Installation
12
4.4.
Power supply
c
For your safety it is mandatory to comply with following prescriptions.
Electric installation must comply with the law in force, particularly with the regu-
lation on the protection line.
c
Advices for a correct installation:
• do not use extension cable, adaptor or multiple socket; when necessary, substi-
tute the Schuko plug with another adequate one.
• Always connect the protection conductor;
• the power socket has to be located in a easily accessible place.
CONNECTION
• Locate the fitting for the connection of the power cable on the rear of the gen-
rator.
• Before of connecting the cable, verify that the POWER switch is in OFF position.
• Connect the power supply cable (2m lenght, Schuko plug IEC320 C13)
4.5.
Warning
e
In case that even momentaneus failures in gas supply (due to interruption of the
power supply, the intervention of a power protection, a failure of the generator)
aren’t acceptable, it will be opportune to forecast a pneumatic switch board that
allows the temporary insert of a secondary gas source more or less automati-
cally.
e
As a precaution the restart of the generator after a interruption of the power
supply isn’t automatic, but manual on operator command.
e
In case that the automatic restart of the generator is necessary after a black-out
during the operation, it is necessary to set this modality in the set-up software.
4.6.
Disposal of the packing
It is recommedend to keep the original packing for possible future handling, as
it guarantees adequate protection to the generator.
To Next Page
Loading...
