Need help?Do you have a question about the Clam EDGE and is the answer not in the manual?
Product intended for ice drilling; handle with caution due to sharp edges and spinning auger.
Keep clothing and body parts away from the powerhead and spinning auger during operation.
Do not alter the product; use only authorized Clam accessories or parts to avoid damage and voiding warranty.
Operators must weigh at least 100 lbs and not be under the influence of mind-altering substances.
Do not use the auger if any part is not in proper working condition; seek authorized repair.
Verify all hardware, especially blade bolts and auger-to-powerhead bolt, are secure before use.
If auger stops cutting, release throttle, pull up to release torque, then reapply throttle.
Turn off the power using the stop switch when the auger is not in use and never leave it unattended.
Steps to remove protective cap, detach socket head bolt, and connect motor shaft to auger, securing with bolt.
Check throttle lever movement, hardware security, and ignition wire connection before starting the auger.
Details on recommended fuels, oils, mixing ratios, and the procedure for adding fuel/oil to the tank.
Step-by-step guide for starting the auger, including primer, decompression, choke, and recoil handle usage.
Guidance on inspecting, gapping, and replacing the spark plug for optimal engine performance.
Instructions for inspecting, cleaning, or replacing the air filter to maintain engine performance.
Procedure for draining fuel, running the engine dry, cleaning, and storing the auger for extended periods.
Information on warranty coverage, exclusions, and procedures for repairs and parts ordering.
General| Brand | Clam |
|---|---|
| Model | EDGE |
| Category | Lawn and Garden Equipment |
| Language | English |
To Next Page
