Assembly of your Edge auger
1. Remove the black protective cap from the motor shaft on
powerhead.
2. Remove the Allen wrench from the auger, then remove the
socket head bolt from the auger with the Allen wrench.
3. Insert motor shaft on powerhead into auger. Line up the
holes between components and reinstall socket head bolt.
Tighten with the provided Allen wrench. Verify the bolt is
tight on a regular basis between uses.
Verifying your Edge auger is ready to start
1. Make sure there is free movement of the throttle lever. Verify it can be fully depressed and then return
to its “idle” position on its own after releasing the throttle.
2. Verify all hardware is secure-especially the four bolts on the blades and the single socket head bolt
holding the auger onto the powerhead.
3. Periodically inspect to make sure the ignition wire is firmly connected to the spark plug.
To Next Page
Loading...