ClareOne Wireless Security and Smart Home Panel Quick Start Guide
Model CLR-C1-PNL1
1
Press the backplate gently
back in place.
P
Remove the backplate,
exposing the battery.
Attach the power supply. Verify
that the battery is plugged in.
D
W
Connect the panel stand,
and then slide to the desired
position.
Remove the backplate,
exposing the battery.
Attach the power
supply to the panel.
Place the
mounting
bracket
against the
wall, and then
use the in-
cluded screws
to attach the
mount to the
wall.
Press the panel onto the mounting
bracket, and then slide the panel
downward.
P
Connect power
supply with brack-
et to the wall.
Do not connect to a
receptacle controlled
by a switch.
W
Follow the displayed onscreen wizard.
O - I A
Use the Clare Controls Install Assist
app to add smart home devices.
E
Rest secure with ClareOne
and enjoy the benets of a
safe, smart, and happy home
with Clare Contols.
T S-
Clare Controls, LLC.
General: 941.328.3991
Fax: 941.870.9646
www.clarecontrols.com
Integrator/Dealer Support:
941.404.1072
claresupport@clarecontrols.com
Note: For additionanl
power options, refer to
the full manual
DOC 1871.
D M N
• e panel must be
mounted at least 1
from a table edge, a
heat or water source,
and any sources of
interference.
• Peel the clear lm from
the anti-skid rubber on the
bottom of the panel mount.
If this lm is not removed,
the panel may slide on a
tabletop.
To view the full
manual DOC 1871,
scan the QR code or
access the link below.
http://bit.ly/35RJzMd
Before starting installation see standards on residential installation, refer to Installation of Residential Fire Warning Systems,
CAN/ULC-S540. e system must be installed in accordance with Chapter 29 of the National Fire Alarm and Signaling Code,
ANSI/NFPA 72.
Homeowners should contact their dealer for assistance.
To Next Page
Need help?
General
