DOC ID - 1937 • Rev 02 1 / 3
TECH BULLETIN
T E CHNI CA L SUPP O RT © 22O C T 20 Cla r e Co ntro l s , LL C .
ClareOne: Remote Power
Last modified: 10/22/20
Introduction
The ClareOne Wireless Security and Smart Home Panel has 2 power options:
localized (using provided power supply with micro USB within 6 ft of the
installation location) and remote (using CAT5/6 or 24AWG or thicker shielded
security wire to extend the reach up to 250 ft from the installation location).
This product bulletin details the remote power option.
Remote power
Installation
For installation locations that are further than 6 ft from the nearest non
switch-controlled outlet, the power supply cable can be removed and replaced
with a CAT5/6 cable or a 24AWG or thicker shielded security wire. This allows
the power supply to be located up to 250 ft away from the panel. Distance is
dependent on type of wire used and number of conductors. See Table 1:
Maximum distance chart, on page 3.
Notes
• When using CAT5/6 cable the single wires must have a minimum gauge of
24AWG. In addition, a twisted pair of the wires must be used to connect to
each of the positive and negative terminals in order to reach 100 ft.
• At no time should the power supply be plugged into an outlet controlled by a
switch.
• Do not use other power supplies, only the provided power supply is suited for
the ClareOne panel. This power supply may be used with different wiring as
listed in this document.
To Next Page
Need help?
General
