Before you begin installation of the rern
verify that you have sufficient
clearanceint
tion. Note that 2.5 inches of mounting dept
rnounting surface) is required to avoid ca
surface is required
in
order to ensure a
installation is complete.
Before cutting any panel, A
ensure that there
is
sufficie
ance behind
the
panel, a
wire harnesses, fuel lin
linkages,
or
any other c
ponents are exposed t
your
choice
of
locatio
damage
to
the
hull
whi
opening.
'::-e
the boat for installation by ca
anels as necessary. Route .
edges, and ensure that no
reed
during reassernbly.
To Next Page
Loading...