Operator Controls 3-15
Section 3. Operator Compartment and Controls
Steering Column Pylon
The steering wheel can be tilted forwards
and backwards in small discrete movements.
Push and hold pylon lock, move the wheel to
the desired position and release lock.
Hood open
Hood release lever is located on the center
of cowl cover under steering column. (C20-
35)
The hood release lever is located on the
left side of hood.(C15-35)
To unlock, pull the lever backward.
Emergency open(C20-35)
If hood latch cables are cutted or crimped,
fold in floor mat corners as illustrated, then
put hook and pull the hood latch levers up
on both ends.
Unitrol Pedal(Optional)
With the Clark Unitrol, the directional control
lever is no longer located on the steering
pylon. The direction of travel and speed of
truck is determined by the Unitrol pedal.
• Forward:To select and move the truck in
the forward direction you must push down
on the(FWD arrow) left side of the Unitrol
pedal. The further the pedal is depressed
the faster the lift truck will go in forward.
• Reverse:To select and move the truck in the forward direction you
must push down on the(REV arrow) right side of the Unitrol pedal. The
further the pedal is depressed the faster the lift truck will go in reverse.
• Neutral:The unitrol pedal activates only FWD and REV. Neutral is acti-
vated only when the parking brake is set.
Pylon Lock
Hood latch lever
Forward
Reverse
To Next Page
