4-12
Maintenance and Care
2. Front wheel
To be able to disassemble the wheels you need previ-
ous experience. If needed, get in touch with a CLARK
dealer.
1) Park the truck on a firm and levelled surface.
2) Turn the key switch to Off and disconnect the battery.
3) Apply the parking brake and place chocks at the rear
wheels so as to avoid any truck movement.
4) Fasten the front of the truck with a lifting sling, assuring
that the total lifting capacity of the tackle is at least 2/3 of
the truck weight.
5) Loosen the wheel nuts slightly.
Do not remove the nuts until the truck is lifted off the
ground.
6) Lift the truck slowly with the tackle until the front wheel is
suspended. Place wooden blocks at each front side of
the frame.
7) Remove the nuts completely and change the wheels.
Be sure that the wooden blocks used to hold the
truck are solid and in one only piece.
8) Install the nuts again with the wheel mounted.
9) Take away the wooden blocks you had placed under the
frame.
To Next Page
Loading...
