3-4 Operator Controls
Parking Brake
The parking brake pedal or lever (depending on your model)
mechanically operates the parking brake.
Parking Brake Pedal
To apply the parking brake, push the
pedal down with your left foot until
pedal stops. The parking brake release
is located just above the brake pedal as
shown. To release the parking brake
pull toward you.
Parking Brake Lever
Pull the lever toward the the operator to
apply the parking brake. The lever
should snap-lock easily into applied
position, when correctly adjusted.
Push the lever forward (away from the
operator) to release the parking brake.
Always apply parking brake before leaving truck.
Never operate your lift truck with a defective parking brake.
Hour Meter
With the key switch on, putting the directional
control lever into forward or reverse positions
also starts the operating hour meter. Use the
hour meter reading to perform prescribed
maintenance.
Parking Brake Release
To Next Page
Loading...
