Clas Ohlson EM6083 User Manual

English
GREAT BRITAIN • customer service tel: 08545 300 9799 e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk
Ver. 20130902
Digital Tyre Pressure Gauge
Art.no 40-8486 Model EM6083
Please read theentire instruction manual before use and save
it for future reference. Wereserve theright for any errors in text
or images and for making any necessary technical changes to
this document. Ifyou should have any questions concerning
technical problems please contact our Customer Services.
Safety
• The electronics and other components contained within
thepressure gauge cannot be adjusted or repaired.
Donotdismantle thepressure gauge.
• Never subject thepressure gauge to pressures exceeding
its rated upperlimit.
• When changing thebatteries, take care not to short-
circuitthem.
• The tyre pressure gauge must not be exposed to extreme
temperatures, moisture, vibrations or direct sunlight for
anextended period oftime.
Product description
• Digital tyre gauge with backlit LCD display.
• Measuring range: 0.3–6.8bar.
• Readings in bar, PSI, kPa or kg/cm².
• Extendable tread depthgauge.
• Automatic shut-off.
• 2×SR44/V357 batteries included.
Care and maintenance
Clean theproduct using asoft, moist cloth. Useamild detergent
and never use solvents or strong, abrasive cleaning agents for
cleaning as these can damage theproduct.
Disposal
This product should be disposed of in accordance with local
regulations. Ifyou are unsure how to proceed, contact your
local authority.
Buttons and functions
Battery replacement
The batteries should be changed when thedisplay isdim.
1. Turnthebattery cover anticlockwise and remove it.
2. Removetheold batteries.
3. Insert2 new SR44/V357 batteries with their negative
terminals facing downwards and then refit thebattery cover.
Note: Whenchanging thebatteries, take care not to short-
circuit them.
General advice
• It is wise to check your tyre pressure regularly. Thecorrect
tyre pressure will help ensure optimum fuel consumption,
improve road handling and reduce tyrewear.
• Always follow themanufacturer’s recommended tyre pressures
which are based on themeasurement of coldtyres.
• A tyre’s rated maximum pressure is often stated on itswall.
• On some models of car therecommended tyre pressures
can be found on thefuel filler cap.
Measuring thedepth oftread
• Press thedepth gauge button.
• The depth gauge has two fixed positions, one at 5 mm and
theother at 27mm.
• Insert thegauge into theshallowest groove of thetread and
measure thedepth.
Specifications
Measuring range 3.0–99.5PSI
0.3–6.8bar
20.7–686kPa
0.3–7 kg/cm²
Accuracy ± 1.5PSI
Resolution 0.5PSI
Units PSI, bar, kPa and kg/cm²
Automatic shut-off After 85 seconds
Batteries 2×SR44/V357, 1.5V
Operating temperature 0–50 °C
Storage temperature -10–55 °C
Size 135×80×32mm
Weight 60 g (incl. batteries)
Operation
1. Turn thegauge on using theon/off button. Thedisplay will
come on and after about 2 seconds “0.0.” will appear, to
indicate that thegauge is ready foruse.
2. The gauge sets automatically to theunit of measurement
that was used last. Theunit of measurement can be
changed by pressing theon/off button. Eachpress changes
theunit in thefollowing sequence: PSI → bar → kPa →
kg/cm² → PSI, etc.
1. On/off button – press
and release to turn
on, press and hold to
turnoff.
2. Nozzle.
3. LCD display – shows
thereading and selected
unit of measurement.
4. Battery compartment
(ontheback).
5. Treaddepth gauge
extend/retract control
button.
6. Treaddepthgauge.
3. Press thenozzle over thevalve of
thetyre. Makesure that thenozzle
forms anairtight seal over thevalve.
Listenfor any air escaping. Ifyou hear
ahissing sound, move thenozzle
alittle until theair stops escaping.
4. Wait for 2 seconds until thereading
on thedisplay has stabilized. Double-
check theunit of measurement and
take thereading.
5. The reading will be displayed for
85seconds before thepressure
gauge shuts off automatically. Ifyou
measure thepressure of another tyre
within 85 seconds, thenew reading
will be displayed.
6. Turn thepressure gauge off by
holding in theon/off button until
thedisplay turnsoff.
1
2
3
5
4
6

Clas Ohlson EM6083 Specifications

General

Brand	Clas Ohlson
Model	EM6083
Category	Measuring Instruments
Language	English